LG Electronics 42LB4D, 47LB5D, 32LB4D, 37LB4D, 42LB5D, 52LB5D Appliance, Duct to Rain or Moisture

Page 3

TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the

presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of elec- tric shock to persons.

The exclamation point within an equi- lateral triangle is intended to alert the user to the presence of important

operating and maintenance (servicing) instruc- tions in the literature accompanying the

appliance.

WARNING/CAUTION

TO REDUCE THE RISK OF FIRE AND ELEC- TRIC SHOCK, DO NOT EXPOSE THIS PRO-

DUCT TO RAIN OR MOISTURE.

WARNING / CAUTION

WARNING / CAUTION

To prevent fire or shock hazards, do not expose this product to rain or moisture.

FCC NOTICE

Class B digital device

This equipment has been tested and found to com- ply with the limits for a Class B digital device, pur- suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi- sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment to an outlet on a circuit different from that to which the receiver is con- nected.

-Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE TO CABLE/TV INSTALLER

This reminder is provided to call the CATV sys- tem installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code pro- vides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry

as practical.

CAUTION

Do not attempt to modify this product in any way without written authorization from LG Electronics. Unauthorized modification could void the user’s authority to operate this product

1

Image 3
Contents LCD TV TruSurround XT Duct to Rain or Moisture ApplianceImportant Safety Instructions Do not use this apparatus near waterIncluding amplifiersthat produce heat Grounding Contents IR Codes External Control through RS-232C Troubleshooting Maintenance Product SpecificationsFeatures of this TV Preparation AccessoriesChannel Remote Control SensorVolume Front Panel Controls37/42/47/52LB5D Back Panel Information Here shown may be somewhat different from your TVVideo device Video Preparation HDMI/DVIComponent Rgbpc Audio RGB/DVI32/37/42LB4D Attaching the TV to a WallStand Installation Only 32/37 inches models Holder Back Cover for Wire Arrangement37/42/47/52LB5D Vesa Wall Mounting Desktop Pedestal InstallationCable Using both cable and antennaAntenna or Cable Connection Antenna analog or digitalHow to use HD Receiver SetupWhen connecting Component cable How to connectOr 3 jack on the set When connecting D-sub 15pin cableWhen connecting Hdmi cable Connect the digital set-top box to HDMI/DVI IN1When connecting Hdmi to DVI cable External Equipment SetupMatch the jack colors = green, PB = blue, and PR = red DVD SetupTurn on the DVD player, insert a DVD When connecting with an S-Video cableRemote control Input jacks on the setVCR Setup When connecting with an antennaSetup When connecting with a RCA cable Connect the AUDIO/VIDEO jacks between TVWhite,and Audio Right = red Other A/V Source Setup When connecting D-sub 15 pin cable PC SetupRGB External Equipment Setup 720x400 Supported Display Specifications RGB/HDMI-PCSupported Display Specifications HDMI-DTV Supported Display Specifications Y, CB /PB, CR /PRScreen Setup for PC mode Press the G button to enter the screen adjustment MenuOverview Press the Enter button Initializing Reset to original factory valuesConnect the USB device to the USB in jacks on the side of TV USB in SetupConnect audio outputs to the TV’s Audio OUT jacks Audio OUT SetupRemote Control Functions VCR/DVD Control video cassette recorders or DVD playersWatching TV / Channel Control Inside the Sliding Cover Watching TVChannel Control Turning on TV WatchingControl Channel Selection If you want to switch the sound off, press the Mute but Ton Volume AdjustmentAdjust the volume to suit your personal preference Press the VOL D or E button to adjust the volumeAudio Setup PictureON-SCREEN Menus Selection OptionAuto ScanAuto Tuning Channel SetupSelect DTV, TV, CADTV, and Catv Add/Delete ChannelManual TuningChannel Editing Input List AV2RGB-PC Component2 Additional cables and settings SimpLink PreparationsSimpLink device with the Hdmi cable When a device is SimpLink FunctionsSimpLink Menu Input Label Media Host Entry ModesUsable USB memory Current page/Total pages Photo ListPhoto Selection and PopUp Menu Selected photo is displayed in full size When selected, the selected photos are displayedMedia PopUp menuMedia Host Music file on your USB device can be played by this unit Music ListMusic Selection and PopUp Menu Picture Control RGB-PC input source use 43 or 169 aspect ratioPreset Picture Settings Picture Mode -PresetYou can also use the Picture menu to adjust Picture Mode Color Tone -Preset Select Color TemperatureTo select the Picture menu Picture Mode -User Mode Manual Picture AdjustmentColor Tone -User Mode Or E button toSelect User XD Picture Improvement Technology Select XDUse the F or G button to select O n or Off Advanced -CINEMA 32 Pulldown Mode Select Black level ADVANCED-BLACKDARKNESS LevelSelect TruM Only 32/37/42LB4D modelsTo original values Picture ResetSound & Language Control Sound & Language ControlYou can also adjust Sound Mode in the Audio menu Preset Sound Settings Sound ModeFront Surround Adjust the sound to suit your taste and room situations3D EchoSound System Press the G button and then useBalance To select the Audio menuSound STEREO/SAP Broadcast Setup TV Speakers ON/OFF Setup Select Language Audio LanguageON-SCREEN Menus Language Selection Caption Mode CaptionText Select Analog Using the Menu buttonDigital Broadcasting System Captions Sound &LANGUAGE Control Your viewing area observes Daylight Saving time Clock SettingAuto Clock Setup Select your viewing area time zoneSelect Manual Manual Clock SetupSetting Select ClockAuto ON/OFF Time Setting Sleep Time Setting Time SettingOptions 10, 20, 30, 60, 90, 120, 180, and 240 minutes Auto SHUT-OFF Setting Parental Control / Rating SET Password & Lock SystemSetting up your Password Chip rating and categoriesLock System Set PasswordUse D E F G button to select a channel and then Channel BlockingTo choose Block Channel With channel numbers and a preview pictureTo choose Movie Rating Movie & TV RatingMovie Rating Mpaa -for USA only Or E buttonTV Rating General -for USA only TV Rating Children -for USA onlyTV Rating english for Canada only Set to even if you turn the TV off KEY LockTo choose Input Block Locking out the front panel controlsTroubleshooting Remote control Doesn’t work Power is suddenly Turned offAppendix Check the signal cable Reinstall the PC video cardCheck the input source Extended Absence MaintenanceCleaning the Screen Cleaning the Cabinet37LB5D Product Specifications32LB4D Programming a code into a remote mode Programming the Remote ControlVCRs Remote control codeHdstb Cable BoxDVD AudioIR Codes Remote Control IR CodesCode Function GND RS-232C SetupType of Connector D-Sub 9-Pin Male External Control Through RS-232CCommunication Parameters RS-232C ConfigurationsThis product has command echo back in the RS-232C Command Set IDTint Sharpness Command Reference ListTransmission Transmission / Receiving Protocol104 105 106 107
Related manuals
Manual 2 pages 46.72 Kb