LG Electronics 42PC5D, 32LC7D owner manual FCC Notice

Page 3

TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the

product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and

maintenance (servicing) instructions in the litera- ture accompanying the appliance.

WARNING/CAUTION

TO REDUCE THE RISK OF FIRE AND ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.

WARNING / CAUTION

WARNING / CAUTION

To prevent fire or shock hazards, do not expose this product to rain or moisture.

FCC NOTICE

Class B digital device

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE TO CABLE/TV INSTALLER

 

 

 

CAUTION

 

 

 

 

 

 

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the National Electric Code (U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of the cable entry as practical.

Do not attempt to modify this product in any way without written authorization from LG Electronics. Unauthorized modification could void the user’s authority to operate this product

1

Page 2 Page 4
Image 3
Page 2 Page 4
Contents 37LC7D 50PC5D 42LC7D 32LC7D 42PC5DPage FCC Notice Safety Instructions Important Safety InstructionsDo not use this apparatus near water Use only with the cart, stand, tripod, bracket Exposed to dripping or splashing and noGrounding Contents External Control Through RS-232C Time SettingIntroduction Feature of this TVPreparation AccessoriesFront Panel Information Front Panel ControlsPlasma TV Model LCD TV Model Remote Control SensorBack Panel Information Back Connection PanelHere shown may be somewhat different from your TV Video ServiceComponent AV OUTBack Cover for Wire Arrangement Connect the cables as necessary How to remove the Cable ManagementEnsure the eye-bolts or brackets are tightened securely Attaching the TV to a WallStand Installation Only 32/37 inches LCD TV models Desktop Pedestal Installation Vesa Wall MountingPlasma TV Model LCD TV Model Antenna Analog or Digital Antenna or Cable ConnectionHow to use External Equipment SetupHD Receiver Setup How to connectTurn on the digital set-top box External Equipment SetupExternal Equipment Setup Refer to the DVD players manual for operating instructions DVD SetupComponent Input ports Connect the video outputs Y, PB, PR of the DVD toVideo input on the set Select AV1 input source by using the Input button onRemote control Connect the S-VIDEO output of the DVD toWhen connecting with an antenna VCR Setup= white, and Audio Right = red Insert a video tape into the VCR and press Play onMono jack of the set Other A/V Source Setup CamcorderEx LCD TV Model Audio 800x600 RGB-PC, HDMI1/DVI-PC modeRGB-PC mode only 640x350 HDMI1/DVI-DTV, HDMI2-DTV mode 59.94Screen Setup for PC mode Overview PhaseInitializing Reset to original factory values Digital Audio Output AV OUT SetupRemote Control Functions Watching TV / Channel ControlWatching TV / Channel Control Inside the Sliding Cover Installing BatteriesVolume Adjustment Turning on TVControl Option SetupON-SCREEN Menus Selection Watching TV / Channel Control LockAuto Scan EZ Scan Channel SearchAdd/Delete Channel Manual Scan Small window at the top-left corner of the screen After EZ Scan on the Setup menuChannel Editing There are two different ways in order to add or deleteDTV Signal Strength Press the G button and then use D or Button to Input Source SelectionWatching Select the source T V, AV1, AV2, Component1Input Label SimpLink Preparations SimpLink Menu SimpLink FunctionsBecome imprinted on the screen and remain visible You can also adjust Aspect Ratio in the Option menuPicture Control Set by programPicture 169Horizon ZoomEZ Picture Preset Preset Picture SettingsPicture Control Color Tone PresetManual Picture Adjustment EZ Picture User ModeSelect EZ Picture Or G button to Color Tone User ModeSelect X D XD Picture Improvement TechnologyAdvanced Cinema 32 Pull Down Mode Advanced Black Darkness Level Select Video Reset Picture ResetInversion OrbiterLOW Power Picture Mode Plasma TV only Sound & Language Control Preset Sound Settings EZ SoundLanguage Control SoundPress the G button and then use F or G button to Make appropriate adjustmentsBalance Select BalanceSound & Language Control TV Speakers ON/OFF SetupPress Exit button to save and return to TV viewing STEREO/SAP Broadcasts SetupStereo, or SAP appear in turn Them with the SAP buttonAudio Language Select Language ON-SCREEN Menus Language SelectionText Caption / TextAnalog Broadcasting System Captions CaptionDigital Broadcasting System Captions Select Caption/TextOr French Size Set the word size Caption OptionCustomize the DTV/CADTV captions that appear on your screen Sound & LanguageTime Setting Clock SettingAuto Clock Setup Time Setting Manual Clock SetupButton and then use Or E button to Auto ON/OFF Timer SettingSleep Timer Setting Auto SHUT-OFF Setting To select the Time menuSelect Auto Off Chip rating and categories SET Password & Lock SystemSetting up Your Password Parental Control / RatingsSet Password Lock SystemRating Channel Blocking External Input BlockingParental Control / Rating Movie Rating Mpaa for USA only Movie & TV RatingTV Rating General for USA only TV Rating Children for USA onlyTV Rating English for Canada only Appendix TroubleshootingRemote control Doesn’t work Power is suddenly Turned off AppendixVertical bar or stripe on Background AppendixExtended Absence MaintenanceCleaning the Screen Cleaning the CabinetModels Product Specifications37LC7D 42LC7D Programming a code into a remote mode Programming the Remote ControlVCR Remote Control CodeHdstb Cable BoxDVD AudioIR Codes Remote Control IR CodesCode Function GND RS-232C SetupType of Connector D-Sub 9-Pin Male External Control Through RS-232CCommunication Parameters RS-232C ConfigurationsTransmission / Receiving Protocol Command Reference ListSet ID OK/NGDatax Set ID DataCr Step
Top Page Image Contents