36PENTOUCH
ENGLISH
Pairing for the First Time
1Check that the LED indicator on the dongle connected to the computer is red.
2Keep the touch pen within 50 cm of the dongle.
3Press the / Home button on the touch pen once.
4The LED indicator on the touch pen will red for 2 seconds and blinks green 3 times when pairing is complete.
5If the LED indicator is red for 2 seconds and blinks red 3 times, pairing is not successful. Please try pairing again.
6Once a pen is paired, the red LED blinks once
when you press the / Home button.
When Pairing Fails
1Pairing fails if the dongle driver is not installed on the computer.
2Pairing fails if the LED indicator on the dongle is not red.
3Remove the dongle from the PC, reinsert it and try pairing.
Unpairing (Resetting the touch pen)
1Press the / Home button on the touch pen and check that the red LED blinks once.
2 Press and hold the / Home button on the touch pen for 9 to 10 seconds.
3When the green light blinks once, release the button. The red light blinks 3 times and the pen is then in its initial state (unpaired).
Caution When Unpairing
1Be careful not to unpair the pen by mistake. If unpaired, try pairing it again.
2If you unpair and pair a normally functioning touch pen, the other paired pen may not work. In this case, unpair the nonfunctioning touch pen and pair it again by following the steps described in the Pairing for the First Time section.
Touch pen Operation
Once paired, you can use the touch pen in the following ways.
1Powering on
-Press the / Home button once. The red and green LEDs will remain lit to indicate that the power is on.
2Powering off
-Press and hold the / Home button. When the red LED turns on once briefly and once again, release the button. The red LED blinks 3 times and the pen is then powered off.
3Pressing the / Home button while using the touch pen
-In the Pentouch program: Shows or hides the toolbar of the feature.
-In Windows: Works in the same way as the
Point the touch pen at an object you want to
4The
If this is the case, use the / Home button
5The touch pen works in the same way as a mouse in Windows.
NOTE
yyAfter 3 hours of a continuous charge, you can use the touch pen for about 8 hours.
yyPentouch operation may not be normal while charging.
yyGreen LED will be turned on during using touch pen. If you don’t use touch pen, it will be automatically turned off after 1 minute.
yyTouch pen LED indicator for battery status
-Charging: Red LED
-Charging complete: Green LED
-Battery level 20% or less: Red LED blinks every 3 seconds
-No battery power: Red LED blinks every second and powers off automatically.