Broan E54000 Prepare Support, FRAME, cont’d, Ducted and NON-DUCTED Hoods, NON-DUCTED Hoods only

PREPARE SUPPORT

FRAME, cont’d.

7.Hang the support frame from the support frame bracket (located on ceiling). Securely fasten with (4) 3.9x9.5mm mounting screws. Fig. 9.

PREPARE THE HOOD

DUCTED AND NON-DUCTED HOODS

1.Assemble the Electrical Mounting Plate to the hood with (2) 3.9x9.5mm mounting screws and (2) serrated washers. Fig. 10.

DUCTED HOODS ONLY

2.Install the plastic discharge collar into the opening of the blower discharge. Fig. 11.

3.Install 6” diameter metal duct over the blower discharge. It must be long enough to reach ducting that discharges to the outside. Duct tape all joints to make them secure and air tight.

NON-DUCTED HOODS ONLY

Note: the following material must be purchased separately for non-ducted recirculation installations:

•Non- Ducted Recirculation Kit RK54

1.Discard the plastic discharge collar supplied with the hood. Install the 5” to 6” adapter (supplied with the non-ducted recirculation kit) over the blower discharge. Fig. 12.

2.Duct tape alljoints to make them secure and air tight.

MOUNTING SCREWS

(3.9x9.5mm)

	SUPPORT
	FRAME
	BRACKET
	SUPPORT
	FRAME
FRONT
		FIG. 9
MOUNTING	ELECTRICAL
SCREWS
	MOUNTING PLATE
(3.9x9.5mm)

FIG.10

DUCTED	DISCHARGE
ONLY
	COLLAR

FIG.11

NON-DUCTED ONLY

6”/5”

ADAPTER

FIG.12

- 10 -