INSTALL FILTERS
(DUCTED AND NON-DUCTED HOODS)
1.To remove the GREASE filter, push in on the metal latch tab and tilt filter downward to remove.
2.To install the GREASE filter, align rear filter tabs with slots in the hood. Depress the metal latch tab, push filter into posi- tion and release. Make sure filter is se- curely engaged after installation.
NOTE: Prior to use, remove protective film from the filter frame.
(NON-DUCTED HOODS ONLY)
1.To remove the CHARCOAL filter, push in on the front filter latch. Pull the filter down to disengage the rear filter tabs.
2.To install the CHARCOAL filter, align the rear filter tabs with slots in the hood. Push the filter up into place until the front latch snaps securely into the slot. Make sure the filter is securely engaged after as- sembly.
3.Install GREASE filter after charcoal filter is installed.
GREASE
FILTERSFIG.21
CLAMP
RECIRCULATION
FILTERFIG.22
WARRANTY
ONE YEAR LIMITED WARRANTY FOR BROAN PRODUCTS
During this
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS, TUBES, HALOGEN AND INCAN- DESCENT BULBS, FUSE, FILTERS, DUCTS, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCT- ING. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by
The duration of any implied warranty is limited to the
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify
In USA - Broan®, 926 W. State Street, Hartford, WI 53027
In Canada - Broan®, 550 Lemire Blvd., Drummondville, QC J2C 7W9
www.Broan.com
- 14 -