Peerless Industries ACC925 manual Installing Adapter Brackets

Page 5

Installing Adapter Brackets

WARNING

Always use an assistant or mechanical lifting equipment to safely lift and position the flat panel screen.

Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to 40 in. • lb (4.5 N.M.) maximum torque.

Be careful not to pinch fingers when pushing screen from the bottom.

3

Hook flat brackets onto wall plate (not included). Then

slowly swing screen in as shown in figure 3.1. Using 4

mmsecurity allen wrench (I) turn clockwise until screw fits firmly against wall plate to prevent screen from being removed. Screen can be adjusted horizontally by

loosening M5 x 25 mm screw (B) on flat brackets.

FLAT BRACKETS

 

NOTE: To lock the screen down, tighten safety/security screws (B) to wall plate as shown.

To remove screen from mount, loosen safety/security screws, swing screen away from mount, and lift screen off of mount.

SAFETY/

SECURITY

SCREW (L)

fig 3.2

WALL PLATE

fig 3.1

3-1

Adjust tension in tilt brackets by rotating ratchet handle.

 

NOTE: If obstruction prevents ratchet handle from rotating,

pull handle out while turning will allow handle to reposition without tightening. Release and turn handle to tighten or loosen.

Ratchet handle must be in the up or down position, or interference will occur while hooking tilt brackets to wall plate. Slowly hook tilt brackets onto wall plate and swing screen down. Using 4 mm security allen wrench (I) turn clockwise until screw fits firmly against wall plate to prevent screen from being removed as shown in figure 3.3.

To remove screen from mount, loosen safety/security screws, swing screen away from mount, and lift screen off of mount.

TILT BRACKETS

WALL PLATE

SAFETY/

SECURITY

SCREW (L)

fig 3.3

5 of 9

ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12

Visit the Peerless Web Site at www.peerless-av.com

For customer care call 1-800-865-2112.

Image 5
Contents Models ACC925 Parts ListReplacing Safety/Security Screw Installing Security Screws for PF and PT wall mount modelsIssued 11-19-08 Sheet # 120-9062-3 For Flat Back Screen Installing Adapter Brackets Installing Security Screws for SA wall mount models Screen MULTI-WASHER Screw Bracket Vesa 100 x Vesa 200 x Mounting Patterns Vesa 100 x Vesa 200 xIssued 11-19-08 Sheet # 120-9062-3 For customer care call Installing and Removing Flat Panel Screen