For Flat Back Screen
1-1Begin with the shortest length screw, hand thread screw through multi-washer and screen brackets (not included) into screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the fastener pack. Repeat for remaining mounting holes, level screen brackets and tighten screws.
NOTE: Spacers may not be used, depending upon the type of screen.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
SCREEN
MULTI-WASHER
SCREW
SCREEN
BRACKET
For Bump-out or Recessed Back Screen
1-2Begin with longer length screw, hand thread screw through multi-washer, screen brackets (not included) and spacer in that order into screen as shown below. Screw must make at least three full turns into the mounting hole and fit snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the fastener pack. Repeat for remaining mounting holes, level screen brackets and tighten screws.
If you have any questions, please call Peerless customer care at 1-800-865-2112.
SCREEN
SCREW
SCREEN
BRACKET
7 of 9 | ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12 |
Visit the Peerless Web Site at www.peerless-av.com | For customer care call 1-800-865-2112. |