For Flat Back Screen

2-1	Begin with the shortest length screw, hand thread through multi-washer and flat or tilt adapter bracket (not
	included) into screen as shown below. Screw must make at least three full turns into the mounting hole and fit

snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer length screw from the security fastener pack. Repeat for remaining mounting holes, level brackets and tighten screws.

NOTE: Spacers may not be used, depending upon the type of screen.

FLAT BRACKETS

SCREEN

MULTI-WASHER

SCREW

FLAT

BRACKET

TILT BRACKETS

SCREEN

MULTI-WASHER

SCREW

TILT

BRACKET

If you have any questions, please call Peerless customer care at 1-800-865-2112.

For Bump-out or Recessed Back Screen

2-2	Begin with longer length screw, hand thread through multi-washer, flat or tilt adapter bracket (not included) and
	spacer in that order into screen as shown below. Screw must make at least three full turns into the mounting hole
	and fit snug into place. Do not over tighten. If screw cannot make three full turns into the screen, select a longer
	length screw from the security fastener pack. Repeat for remaining mounting holes, level brackets and tighten
	screws.
	FLAT BRACKETS	TILT BRACKETS

SCREEN
SPACER	MULTI-WASHER
SPACER
	SCREW
	FLAT
	BRACKET

SCREEN

MULTI-WASHER

SPACER

SCREW

ADAPTER

BRACKET

If you have any questions, please call Peerless customer care at 1-800-865-2112.

4 of 9

ISSUED: 11-19-08 SHEET #: 120-9062-3 06-29-12

Visit the Peerless Web Site at www.peerless-av.com

For customer care call 1-800-865-2112.