Connecting the Mediamaster
The box for your Mediamaster should contain the following items:
• the Mediamaster
• remote control with 2 AAA batteries
• SCART cable (fully connected; 1,0 metre)
• | mains cable |
• | RF cable |
| SCART cable RF cable Mains cable |
• Owner’s manual including a software license agreement
Remote control Owner’s Manual
About the SCART sockets
The rear panel of the Mediamaster is equipped with 2 SCART |
|
sockets (see diagram). When you connect other devices to any |
|
of these sockets, always use fully connected SCART cables (as |
|
the one supplied.) There are SCART cables available which do not | SCART socket |
have all the pins connected. The picture quality could be reduced | |
if you use them. |
|
Preparing the remote control
•Remove the cover on the battery compartment at the bottom of the remote control.
•Insert the 2 AAA; 1,5 V batteries, as shown in the diagram, tak- ing care to observe the + and - markings indicated inside.
•Replace the cover.
About the digital transmission
Digital Radio and TV signals can be blocked by buildings, moun- tains and the terrain. Depending on if the receiver is located in a valley, behind a mountain or in a concrete building, the quality of reception may vary considerably.
As with most other transmissions, bad weather does affect the reception quality.
GB 7