Connecting the Mediamaster
Connecting a HiFi system
•Connect an RCA/Cinch stereo cable from the AUDIO L R sock- ets on the Mediamaster to the LINE, AUX, SPARE or EXTRA input sockets on your HiFi system.
•If available you can connect an RCA/Cinch single cable from the DIGITAL AUDIO socket on the Mediamaster to a HiFi sys- tem equipped with digital audio input. This output is also used for connection to an external Dolby™ digital decoder.
Note: To avoid interference you must use screened audio ca- bles. Never connect digital output to any analog input.
Procedure when RF connections are used
This procedure is necessary only when your Mediamaster is connected to the TV with an RF lead and no SCART leads are used.
To tune your TV to the RF signal you might also need your TV manual in addition to this manual. The steps below explain what to do if you have been unable to use SCART leads in your con- nection.
•Plug in your Mediamaster to the mains.
Tuning your TV to the Mediamaster
•Select a programme number on the TV that is not currently used for other TV channels.
•Follow the instructions in your TV manual to tune the TV chan- nel selector to UHF channel 43 (this is the Mediamaster’s fac- tory preset UHF channel).
•Follow the instructions in your TV manual to store this UHF chan- nel as the channel used by your Mediamaster. You will have to select it when you want to watch terrestrial digital TV channels.
•When the First time installation menu is visible, press the Select button on the Mediamasters remote control to start the installation procedure.
If the picture quality is bad you can later change the predefined UHF channel 43 to any other figure between 21 and 69. You will also have to tune your TV to the same (= the new) channel number. Please see RF modulator output channel setting on page 30.
When you have a VCR connected it must be tuned to a different UHF channel (between 21 to 69) than the Mediamaster.
RF
GB 15