Sima Products SUR-25 user manual Deleting devices, Learning from Another Remote Control

Page 27

	Deleting devices		SUR-25 User Manual
	2. Select the device you
	wish to delete. Make sure the
	device name displayed in the
	upper right hand corner of the
	touch screen is the device you		&
	wish to erase.
			2

3.Press OK to erase this device. Or press EXIT to cancel without erasing the device.

Ch.

Page

SUR-25 User Manual

Learning codes

Learning from Another Remote Control

To teach the codes from your remote, set both remotes on a flat surface facing each other. Be sure to point your device’s remote control at the SUR-25’s learning eye, which is located at the bottom of the unit. Do not use the other eye located at the top of the SUR-25. You do not have to turn on the actual device (TV, VCR, etc…). Refer to the following illustration.

Figure 7: Using the Learning Eye

Ch.

Page

Image 27

Contents Day Limited Warranty WarrantyCopyright TroubleshootingPreface About this manualTable of Contents Creating and Using Macros Appendix C TroubleshootingIntroducing the SUR-25 Appendix B AccessoriesSUR-25 Features AccessoriesIdentifying Components Appendix a SpecificationsSpecifications Unpacking the SUR-25Beep Toggling Features OverviewResetting to Factory Defaults Getting StartedBacklight FeaturesFeatures Backlight Time PeriodChanging SUR-25 Parameters Power Down Time PeriodInstalling Batteries Power DownTurning the Touch Screen On Touch ScreenDisplaying Version Number Touch ScreenTouch Screen Buttons Using Sleep ModeSleep mode Rubber ButtonsProgram Menus Transmitting System SetupUsing Quick Channel Lists MenusDeleting Channels from a Quick Channel List Setup MenuSetup Menu Delete channelsDelete Menu Delete MenuMacro Menu Using Quick Channel ListsSetting up Channel Lists Quick ChannelsDate and Clock Setting Up the SUR-25Setting Up Macro TimersChoose Device Setting Up a New TimerPress OK to confirm timer type Choosing a DeviceNew device Other FeaturesUsing Timers Other FeaturesNaming devices Using MacrosLabeling a Device MacrosAvailable LCD choices for all Changing the Touch Screen LayoutLCD layout Button to change to the Touch &1Press OK to confirm your changes Programming Infrared Codes ProgrammingDefine Macro Pre-set codes Using Pre-programmed Manufacturer CodesCreating a Macro Sequence Creating and UsingMacros Introduction to MacrosTo use automatic search Automatic Search Controlling the DeviceOperation Auto searchChanging Touch Screen Pages Using the Learning FunctionControlling Devices Selecting a Device to ControlLearning from Another Remote Control Deleting devicesSelect the device you Wish to delete. Make sure Deleting a Device Deleting buttons Deleting a Specific KeySoftKey Press and hold the Setup Button on Touch ScreenCollecting Unrecognized Infrared Codes Learning codes Collecting codes

Deleting devices

2. Select the device you

wish to delete. Make sure the

Learning codes

Learning from Another Remote Control

Figure 7: Using the Learning Eye