| Features |
|
| |
| 2 | Features (cont.) |
•LCD Indicators: LCD stands for Liquid Crystal Display and these indicators at the top of the display give you feedback and information. You can look here to see if the beep is turned on, if the battery has low power, if the infrared signal was sent OK or if there was an ERROR, and also to see which page of Touch Screen buttons you are looking at.
•UART Port: This port allows you to connect the
•Backlight / Sleep Key: If pressed quickly, this key will activate the Touch Screen backlight. If held down for three seconds you will enter the Sleep menu.
•Page / Date Key: This key allows you to switch between Page 1 and Page 2 of Touch Screen Buttons.
•Learning Eye: This is an infrared sensor used to detect other remote controls infrared signals. Aim your existing remote control here when using the
•Device Buttons: These 8 buttons allow you to switch between different devices. Each button may have more than one device. (For example, the TV button may have TV1 and TV2 for different TVs in your house.) Repeatedly press the same device button to cycle through all the device names . The
•Touch Screen: The touch screen acts as a “virtual” keyboard on the
•Function Keys: These keys allow you to enter the SETUP, DELETE, and MACRO menus. To enter any function menu, press and hold the appropriate function key for three seconds.
Ch.
2
Page
| Backlight |
Backlight Time Period
This setting specifies how long the
To enter the SETUP menu press SETUP button for three seconds. Complete the password protection sequence 2...4...6...8.... Use the arrow
buttons to select the LITE menu.
1.Use the arrow keys to set the backlight period. If using software version 1.11, set the time period from 05 to 60 seconds. If using software version 1.12 and higher, set the time period from 02 to 60 seconds.To determine version number, see page 51.
With either software version you can disable the backlight by setting the time to 0. Press OK when finished and EXIT to return to the SETUP Menu.
Ch.
7
Page
8 | 53 |