QSTD2400 Series DVR User’s Manual
4.2.6 Motion Configuration
Click MOTION to enter Motion Configuration as Fig 4.11 Motion Configuration.
Fig 4.11 Motion Configuration
Here users can set motion sensitivity, detection area, and alarm out. The following are the Explanations of each option.
Enable: Enable motion detection.
Trigger: Setup similar to that of sensor alarm. Do not link motion to the channel where the speed dome is located because the constant motion of the speed dome will always trigger motion recording. For example, if the speed dome is on channel 1 do not setup motion detection for channel 1, you can set it for 2 through 16.
Area: Set sensitivity and motion detection area. System supports multiple detection areas as shown in Fig 4.12 Detection Area Configuration. Click the blocks or drag mouse to enable or disable. Red means unchecked or inactive, transparent (Blue) means available. Click Save to save and exit.
Fig 4.12 Detection Area Configuration
Sensitivity: Set detection sensitivity from
Exit: quit without saving
Holding time(s): the amount of time between two consecutive motion events, similar with that of sensor alarm.
33