| Error! Use the Home tab to apply |
|
| ||
|
| 1 to the text that you want to |
|
| |
| appear here. Error! Use the Home |
|
| ||
| tab to apply | 1 to the text that |
|
| |
| you want to appear here. |
| SuperDVR & QSDT8PCRC | ||
| 标题 |
| 标题 |
| User Manual |
| DSCP, | ||||
| 3. | Address |
| ||
| Communication address of P.T.Z device (ID number) |
| |||
|
| 5.7.2 Serial Ports Setup |
| ||
| Users should first enable the P.T.Z control function of a certain camera and | ||||
| select a port number in P.T.Z Protocol Setup (refer to |
set corresponding parameters in the area below:
Figure5-19 P.T.Z Serial Port Setup
1.Port
Users can set port number.
2.Baud Rate
Set P.T.Z device Baud Rate to match setting on camera, default value is 9600.
3.Data Bits Default value is 8.
4.Parity
Odd and even parity bit, default None.
5.Stop Bits Default value is 1.
NOTICE: Users should look at the control board of the P.T.Z device and get the Baud Rate, Protocol, and Address first, then enter the same values into the SuperDVR program.
36