C. Sensor Installation
The DVR can support up to 4 sensors (not included in the DVR package) in up to four locations.
There are two steps for sensor installation:
(a)Connect the sensor signal lines to the signal input terminal.
(b)Connect the sensor power lines to the appropriate power source.
In general, there are three different types of sensors readily available for purchase:
(1)
Close/Open. Below is a brief diagram on how each type of sensor is installed into the DVR. The procedure for sensor installation is shown below:
Notice:
*After you install sensor(s), the programmed recording mode must be set to “S” for “sensor” during the hour that you are recording (See “Chapter 5.H.Record Schedule”).
*Contact an authorized dealer for information about buying the appropriate sensors for your needs and for information concerning proper installation procedures.