Operation
Connect the power adapter to the DVR this will turn on the DVR.
Make sure that a hard drive and camera(s) are properly installed.
Start TV Monitoring and Recording.
After installation of hard drive, the hard drive must be fixed tight enough with screws.
If the power is turned off while recording (i.e. a power failure), the DVR will enter “Power Recovery” mode at start up, detect that it has been shut down, and then
5. HARDWARE SETUP
5.1 Hard Drive Installation
This model uses an internal SATA hard drive, and comes with a 250GB hard drive
If you want to install a larger hard drive you would need to remove the cover of the DVR, remove the power and data cables from the existing drive and unscrew it from the base, then screw in the new hard drive and attach the power and data cables to it.
Connect the cables as follows:
5.2 Monitor Connection
To display video image from cameras on the monitor, the DVR’s video output signal needs to be transferred to your TV set or monitor.
Connect a monitor to the “VIDEO OUT” port on the DVR
6