Insignia NS-LTDVD19-09CA manual Connecting a computer, Connecting a component video device

08-1154 NS-LTDVD19-09CA - ENG.fm Page 11 Monday, April 28, 2008 10:03 AM

Insignia NS-LTDVD19-09CA 19” LCD TV/DVD Combo

2 Plug RCA audio cables (4) into the S-Video	Connecting a computer
device audio output jacks and into the AUDIO
L and AUDIO R jacks on the back of your TV.

3 Turn on your TV.

4 Press INPUT and / to select S-Video.

Connecting a component video device

1

RF INPUT

1

HDMI INPUT VGA INPUT AUDIO

2

3 4

CPB CPR

L	FOR
	ONLY
	L

2

4

3

To connect a progressive-scan or HDTV video source to Y/Pb/Pr jacks:

1Plug a component video cable (2) into the progressive-scan or HDTV video device (3) and into the Y/Pb/Pr jacks on the back of your TV (1).

2Plug the RCA audio cables (4) into the audio out jacks on progressive-scan or HDTV video device and into the lower AUDIO L and AUDIO R jacks on the back of your TV.

3Turn on your TV.

4Press INPUT, then press / to select Component.

5

6

To connect a computer using VGA:

1Plug a VGA cable (3) into the VGA port on the computer (5) and into the VGA INPUT port on the back of your TV.

2Plug an audio cable (4) into the audio jack on the computer (5) and into the AUDIO VGA INPUT port on the back of your TV.

3Turn on your TV.

4Press INPUT, then press / to select VGA.

Caution

Your TV will automatically turn off after one minute if there is no signal in VGA mode.

To connect to a computer or other HDMI device using the HDMI jack:

1Plug an HDMI cable (2) into the HDMI port on the HDMI device (6) and into the HDMI INPUT port on the back of your TV.

2Turn on your TV.

3Press INPUT, then press / to select HDMI.

Note

When the computer goes into standby mode, your TV turns off. If your TV does not turn on when you “wake” your computer, press POWER on your TV or remote control.

www.insignia-products.com 11