Insignia NS-LTDVD19-09CA manual Specifications, Legal notices, Macrovision statement, Copyright

08-1154 NS-LTDVD19-09CA - ENG.fm Page 31 Monday, April 28, 2008 10:03 AM

Insignia NS-LTDVD19-09CA 19” LCD TV/DVD Combo
			Specifications
Problem	Solution
Stripes on picture	Check for interference from other electronic
	devices, such as radios and televisions, and		LCD	Panel	19" WIDE TFT LCD
	keep magnetic or electronic devices away from
				Resolution	1440 × 900
	your TV.
				Viewing angle	150°/135°
Bad stereo or	A long broadcast distance, or interference from
SAP sound	radio waves, can cause bad sound reception. If			Contrast ratio	700:1(Typ.)
	so, change the mode to Mono.
				Brightness (cd/m2)	300 (Typ.)
Remote control	Remove obstacles between the remote control
			Dimensions	With stand	18.5 × 15.4 × 7.9 in.
does not work	and the player. Point the remote control at your
	TV's IR sensor. Install fresh batteries.				(470 × 390 × 199.5
					mm)
"Input Signal Out	Check the resolution and frequency of your
of Range"	computer, and adjust it to the optimum			Without stand	18.5 × 13.8 × 2.7 in.
appears on the	resolution for this TV: 1440×900 at 60Hz.				(470 × 350 × 69 mm)
screen
			Weight		15.48 lbs. (7.02 kg)
“No Signal”	Make sure that the cable is firmly connected to
appears on the	the computer and TV.		TV	TV standard	NTSC
screen
				Tuning system	Electronic tuning
Image is not clear	Adjust the phase control.				system
				Frequency range	VHF/UHF
Image is not	Adjust the horizontal control.
centered
				Stereo	BTSC
Picture has a few	A few bright or dark dots on an LCD screen is
				CATV	125 channels
bright or dark	normal. It does not affect the operation of this
dots	TV.		Power	Input	100-240V AC, 50/60 Hz
DVD				Consumption (Max.)	75 W
			Sound	Output	3W×2
			Terminals	A/V in	Video, S-Video, Audio
Problem	Solution
					L/R
No sound	• Make sure that your TV or amplifier is			Component	Y, Pb (Cb), Pr (Cr)
		working correctly.
				PC in	D-SUB 15-pin RGB in
	• Make sure that the amplifier is set to
		receive DVD signal output.
				HDMI	HDMI compliant (type
No image	• Make sure that your TV is working				A connector)
		correctly.		Antenna in	F-type
	• Make sure the color system is set
			DVD player	Signal System	NTSC
		correctly.
				Playable discs	DVD:12cm
Bad sound	• Make sure that the audio output mode is
quality		set correctly.			CD:12cm
	• Make sure that the audio connection
			Operating	Temperature	5°C~35°C
		between your TV and amplifier (if used)
			conditions	Humidity	20%~80% RH
		is secure.
				Atmospheric pressure	86KPa~106 KPa
Disc cannot be	• Make sure that the disc is inserted with
played		the label facing forward.	Legal notices
	•	Clean the disc.
	• Moisture has condensed in the player.
		Remove the disc and leave the player on	Macrovision statement
		for about an hour to dry out.	This product incorporates copyright protection technology
The player	Disconnect the power plug, then reconnect it.
			that is protected by method claims of certain U.S. patents
doesn't operate			and other intellectual property rights owned by Macrovision
normally			Corporation and other rights owners. Use of this copyright
			protection technology must be authorized by Macrovision
Remote control	• Remove obstacles between the remote
			Corporation, and is intended for home and other limited
does not work		control and the player.	viewing uses only unless otherwise authorized by
	• Point the remote control at your TV's IR		Macrovision Corporation. Reverse engineering or
		sensor.	disassembly is prohibited.
	•	Install fresh batteries.	Copyright

© 2008 Insignia. Insignia and the Insignia logo are trademarks of Best Buy Enterprise Services, Inc. Other brands and product names are trademarks or registered trademarks of their respective holders. Specifications and features are subject to change without notice or obligation.

For service and support call (877) 467-4289.

www.insignia-products.com 31