IBM LC-UXT3 manual Connecting Projector, Terminals of Projector, Replacement of Terminal

CONNECTING PROJECTOR

TERMINALS OF PROJECTOR

This projector applies various input/output terminals and 4 terminal slots for expansion to tune to diversity of signals from computers and video equipment. 4-built-in Terminal Slots enable you to arrange desired combinations of input sources just by changing Terminal Boards. For Terminal Boards, contact sales dealer where you purchased a projector.

4 TERMINAL SLOTS (Factory set)

SERIAL PORT IN			DVI			AUDIO	L	CONTROL PORT
						R
						(MONO)
SERIAL PORT OUT		R/Pr	G/Y B/Pb H/HV		V	AUDIO		CONTROL PORT
						R	L
						(MONO)
R/C JACK	USB	VIDEO/Y	C	S-VIDEO		AUDIO
						R	L
						(MONO)
AUDIO OUT						AUDIO		CONTROL PORT
R	L		ANALOG RGB
						R	L
INPUT/OUTPUT	RESET
TERMINALS	(MONO)					(MONO)

INPUT 4 INPUT 3 INPUT 2 INPUT 1

DVI Terminal

5 BNC Terminal

AV Terminal

HDB 15-PIN Terminal

REPLACEMENT OF TERMINAL

NOTE; When replacement of terminal board, MAIN ON/OFF switch should be OFF position.

1	Remove 2 Screws on terminal.
2	Pull out terminal by holding handle.
3	Replace terminal. Insert terminal along Guide to fit Plug
	into Socket.
4	Tighten screws to secure terminal.

NOTES ON ORDERING OR USING

OPTIONAL INTERFACE BOARD

When ordering or using Optional Interface Board (Terminal Board), contact your sales dealer. When con- tacting the sales dealer, tell the Optional Control Number (Op.cont.No.) in the menu that is located under Language Select Menu. (See page 40.)

Plug

Screws

Guide

Socket

Figure shows HDB 15-PIN terminal.

11