Preparing the Table
Extron recommends cutting the hole in the table with the Extron metal routing template (see “Routing Template Part Numbers” on page 11 for part numbers).
NOTE: The hole can be also cut with a CNC wood router or a paper
ATTENTION: Potential damage to property.
•Exercise care to prevent scarring or damaging the furniture.
•The opening in the table should be cut only by licensed and bonded craftspeople.
•The routing templates for various Cable Cubby models are not interchangeable. Using the wrong template will produce an improper fit.
1. Prepare the Routing Template
NOTE: Save and reuse the metal routing template for installing additional Cable Cubby 200 models.
a.Cut 1/2 inch x 4 inch strips of soft, finished lumber to a length that is long enough to span the edges of the mounting surface.
b.Place the template over the strips so that the opening reaches the desired mounting location and the strips span the surface.
c.Using at least four mounting screws, secure the mounting template to the lumber so that the
ATTENTION: Potential damage to property. Protruding screws will scratch the table.
2.Prepare the Table with a Router
a.Mark the desired mounting location on the tabletop. Ensure the enclosure will face the desired direction.
b.Place the mounting template assembly on the mounting surface with the lumber strips against the table surface and centered on the marked location. If necessary, use a square to ensure that the template is properly positioned. Extron is not responsible for improperly positioned Cable Cubby models.
c.Secure the assembly to the table with
1/2” x 4” Soft, Finished
Lumber
4 Screws Min.
Routing Area
Width of Mounting Surface
1/2” x 4” Soft, Finished
Lumber
Clamps (4)
Routing Template
Sandwich Table
Between Soft Lumber
Cable Cubby 200 • Installation | 6 |