Mounting the Cable Cubby
ATTENTION: Potential damage to property. The flanged edges of the top of the surface enclosure are sharp and soft, making them easy to nick or bend. Handle the enclosure with care to prevent personal injury and to avoid damaging the enclosure.
1. Test the Fit
a.Remove the plastic strips on finished surfaces
of the Cable Cubby.
ATTENTION: Potential damage to property. Do no use isopropyl alcohol or other solvents to clean the Cable Cubby. Strong solvents will ruin some finishes.
b.Carefully lower the Cable Cubby into the hole to test the fit. If necessary, remove the enclosure and carefully enlarge the opening.
2.Fasten the Cable Cubby to the Table
a.Drill 1/8 inch (3 mm) pilot holes 1/2 inch
(12 mm) deep into the table using the mounting holes at each of the four corners of the unit.
b.Use the four included
3.Dress the Cables
a. Under the table, dress the cables to prevent snags or tangles. Allow at least 36 inches
(0.9 m) of cable loop for each cable and secure the cables behind the flange on the underside of the unit.
b. Connect cables to the AV system and connect the AC power cord.
NOTE: The Extron Cable Retractor provides a convenient way to dress cables (see www.extron.com for Cable Retractor part numbers).
Connect to AV
Device or System
Secure cables w/ zip ties
to holes in rear ofPower Cord Cable Cubby.
Cable Cubby 200 • Installation | 9 |