3.Install Any Necessary Split Grommets and Hole Plugs
a.Slip the appropriate split grommet over each cable with the flange of the grommet toward the connector that will be accessible inside the Cable Cubby. Snap the grommets into the channels.
b.If necessary, snap the included hole plugs into unused holes.
4.Adjust the Cable Position
The Cable Cubby 200 has four cable
a.Choose the row that best lifts the cable connectors off the cable
b.Insert the
c.Loosely install the Phillips head screws and washers so the
d.Install a second
e.Slide the
f.Tighten the Phillips head screws of the
g.Repeat steps 4a through 4f until all the cable connectors have been accompanied with
5.Install Optional Passive AAPs
The
a.Unscrew the nuts on the underside of the shelf that fasten the set of
b.Connect cables to the rear of the AAPs to be installed before attaching it to the enclosure.
c.Insert the screws of the AAPs through the holes in the shelf. Secure the AAPs to the shelf with the provided captive washers and
Ü
Cable
á
Cable Cubby 200 • Installation | 8 |