Extron electronic 200 manual Installing and Cabling AAPs, Plan for AAPs, Cable the AAPs

CAUTION: Risk of injury to the eyes. Wear safety glasses when operating the router. Failure to comply can result in injury.

d.Using a router with a 5/8 inch (16 mm) outside diameter guide bushing and a 1/2 inch

(12 mm or 12.7 mm) diameter straight router bit, carefully cut the opening in the surface.

e.Remove the C-clamps and the routing template assembly.

Installing and Cabling AAPs

Router

CABLE	CUBBY
		20000

CA
USE BLE	S
RA	CU
	CUBBY	200

The Cable Cubby 200 has a fixed AAP shelf. Three half-moon cutouts in the set of cable pass-through (split) AAPs loosely channel three cables in the Cable Cubby. Each channel and each associated split grommet is a different size. Match the diameter of the cable to the size of the channel. For Cable Retractor installation details, refer to the Cable Retractor User Guide on the Extron website, www.extron.com.

1. Plan for AAPs

TIP: Typical installations consist of a VGA (large hole), an audio (small hole), and a network (medium hole) cable. In a non-standard installation, match the diameter of the cable to the size of the hole that best applies.

NOTE: Pass-through AAPs can also be replaced by optional passive AAPs for further customization (see “Installing Optional Passive AAPs” on page 8).

2.Cable the AAPs

a.Remove a segment of a set of split AAPs by unscrewing the nuts on the underside of the shelf.

b.Thread the cables through the half-moon cutouts of the pass-through AAP segment mounted to the shelf bracket (see É).

c.Secure the remaining pass-through AAP segment to the shelf bracket with the provided #4-40 nuts.

Large Medium Small

Cable Hole	Hole Size	Grommet Size
Large	0.625” (1.59 cm)	0.453” (1.15 cm)
Medium	0.562” (1.43 cm)	0.390” (.99 cm)
Small	0.500” (1.27 cm)	0.312” (0.79 cm)

É

Ç Secure one segment first.

#4-40 Nut w/ Captive Washer

Cable Cubby 200 • Installation 7