TRIAX DVB 75SI
&RQQHFWLRQRIWKHµ/1%,1387µVDWHOOLWHVLJQDO
Connect the aerial cable (double-shielded 75 Ohm SAT coaxial cable) from the LNB unit of the dish to the F-connector of the receiver.
If the F-connector has not yet been mounted on the cable:
•Strip the cable as illustrated on the drawing, and
2 8 mm
3
•Position the F-connector correctly on the cable and firmly secure it. Make sure that the cable shield contacts the F-connector sheath without the shield contacting the inner conductor because that would lead to a short circuit.
Note!
•Your DVB 75SI has a pre-programmed channel list as it has been prepared to receive channels from satellites which especially service the Scandinavian countries: Thor/Intelsat (1 deg. West) and Sirius (5 deg. East) in the order mentioned.
If your satellite dish has also been set up to receive these two positions we recommend that you connect them via a 2x1 DiSEqC switch, in the same order (viz.: Thor/Intelsat as position 1 (DiSEqC A/A) and Sirius as position 2 (DiSEqC B/A)). The DVB 75SI has been pre-programmed for this, and you do not have to take any further action. If you can receive other positions, you should use a 4x1 DiSEqC switch. The preprogramming also includes ASTRA (19 degrees East) and Eutelsat/HotBird (13 degrees East).
If you want another set-up, you must alter the settings under ‘LNB Settings’ in the main menu correspondingly. For further details, please see chapter 4.3.
Please note that a later resetting of the receiver to the factory setting will also reset this setting to the basic setting.
•We recommend that you record how you have set up your satellite dish and the LNBs in order for you to have this information on hand if you want to reset or change the system settings later.