Triax DVB 75SI manual RQQHFWLRQRID6XSHU9+6YLGHRUHFRUGHU

TRIAX DVB 75 SI

UHF transmitter channel chosen:

_________

VCR connection

Analog audio

•Confirm the choice of channel by pressing [OK], then a dialogue box will appear which you will have to acknowledge by pressing [OK] or [back]. Now the UHF transmitter channel of the satellite receiver will be changed correspondingly, and the picture will therefore disappear from you TV which is still set on channel 38.

•Now set your TV to receive on the new UHF transmitter channel of the satellite receiver. If you still do not receive a good picture without interference on the channel just set, you must repeat the procedure described until you find a channel.

•When you have found a UHF channel without interference, do not forget to store it on your TV. The satellite receiver automatically stores the new setting when you press the [menu] button on the remote control.

•Disconnect the satellite receiver from the mains.

REMEMBER: Please note that a later resetting to factory settings always resets the satellite receiver to the original UHF channel setting on channel 38. We therefore recommend that you make a note of the UHF channel that you change your satellite receiver to use here to your left to enable you to make the same setting again after a resetting without having to experiment first.

￿￿￿￿&RQQHFWLRQ￿RI￿D￿9&5￿

Connect your VCR via a SCART cable to the SCART connector marked VCR on the satellite receiver. At playback VCRs normally send a switch signal to the satellite receiver via the SCART cable. Thus the VCR signal is automatically transmitted to the TV where it is displayed on the screen.

If your VCR does not send this switch signal, you can switch by means of the [EXT] button of the remote control.

￿￿￿￿￿￿&RQQHFWLRQ￿RI￿D￿6XSHU￿9+6￿YLGHR￿UHFRUGHU

If you have a Super VHS VCR, you can make Super VHS quality recordings from your digital satellite receiver. See sections 4.3.2 and

4.3.3for information on how to set the signal type of the two SCART connectors (RGB, Composite video and S-VHS)

￿￿￿￿&RQQHFWLRQ￿WR￿D￿+L￿IL￿DPSOLILHU￿

￿￿￿￿￿￿$QDORJ￿DXGLR￿FRQQHFWLRQ￿

To get the optimum sound quality you can connect the satellite receiver to a Hi-fi amplifier. To do this you must connect the Audio R and Audio L connectors at the back of the satellite receiver with a suitable cable to the corresponding input on your Hi-fi amplifier (e.g. AUX, TAPE1 or TAPE2).

13