TRIAX DVB 75SI
7URXEOHVKRRWLQJ
Problem | Cause | Remedy |
No picture, no sound, and front | No mains voltage | Check mains cable and socket |
display not illuminated |
|
|
|
|
|
No picture, no sound, but front | Short circuit in LNB supply, | Turn off DVB 75SI, remove |
display illuminated | defective cable connection | short circuit and turn receiver |
|
| on again. |
|
|
|
| Defective or wrong cable | Check all cable connections |
| connection |
|
| Defective LNB | Replace LNB |
| Wrong adjustment of LNB unit | Turn the dish so that LNB units |
|
| point at satellite correctly. |
Periodic squares in the picture | Strong rain or snow | Remove snow from the dish |
(macro blocking) |
|
|
Periodically frozen picture, no | Wrong adjustment of dish | Adjust the dish correctly (within |
| 1 degree) | |
sound | Dish too small | Use bigger dish |
Periodically black screen and | An obstruction between dish | Make sure that there are no |
and satellite (e.g. a tree) | obstructions. | |
the message 'No signal' |
|
|
|
|
|
Sound OK, no picture | Radio reception has been | Switch to TV reception [TV/R] |
| selected |
|
Poor picture and sound on | The dish has been turned or is | Check satellite dish and LNB. |
channels that were previously | defective |
|
OK | The programme is transmitted | Carry out programme search |
| on another transponder |
|
| The programme is no longer | None |
| transmitted |
|
The remote control does not | Flat batteries | Replace batteries |
work |
|
|
7HFKQLFDOWHUPV
Aerial cable:
Connecting cable between the modulator of the satellite receiver and the TV antenna input, as an alternative if no SCART connector is available.
AV: see SCART
Conax:
Digital coding method.
Data compression/MPEG1/MPEG2:
Transmission of the present TV standard (625 lines and 50 Hz picture frequency) requires a digital data amount of 216 Mbit/s. This would require transmission
24