Denon DN-V210, DN-V310 manual 96k Factory default, 96k48k, MAX Factory default, Mid, Min

3

wWhen “96k LPCM OUT” is selected:

Use the 5 and ∞ cursor buttons to select the conversion mode, press the ENTER button to decide.

96k (Factory default)

When playing linear PCM DVDs that are not copyright-protected, for 2-channel PCM audio signals up to 96 kHz, linear PCM signals are output as such without being converted from the digital outputs.

PCM signals of 48 kHz/16 bits and lower are output, regardless of whether they are copyright-protected or not.

For DVDs containing multi-channel PCM signals, the digital signals are down-mixed for output into two channels, front left and right. (Only the front left and right channels are output for sources for which down-mixing is prohibited.)

When playing copyright-protected linear PCM DVDs, in consideration of copyrights, no digital signals are output for sources exceeding 48 kHz/16 bits. When playing such sources, either set to “96k>48k” or make analog connections. (See page 10.)

96k>48k

Linear PCM and packed PCM signals are converted to 44.1 kHz or 48 kHz and output. (The PCM digital audio output signals are converted to 48 kHz or less in consideration of copyrights.) When making digital connections to an AV amplifier that is not compatible with 96 kHz/88.2 kHz signals, set to “96k>48k”.

When playing DVDs recorded in linear PCM or packed PCM and the unit is set to output digital and analog audio signals simultaneously, the analog audio output signals are also converted to 48 kHz or below, so we recommend setting to “96k” and also making analog connections.

eWhen “DYNAMIC RANGE” is selected:

Use the 5 and ∞ cursor buttons to select the “ON” or “OFF”, press the ENTER button to decide.

MAX (Factory default)

Dynamic range control is not operating. You can hear the original audio.

MID

Dynamic range control operates at the mid-level. The size difference between sounds becomes a little smaller.

MIN

Dynamic range control operates at the maximum level. The size difference between sounds is reduced to the smallest level.

ENTER

Remote control unit	Remote control unit
w
AUDIO SETUP
DIGITAL OUTPUT	PCM
96K LPCM OUT	96k
DYNAMIC RANGE	MAX
SELECT:	SET: ENTER BUTTON
SET 96k LPCM OUT

e

AUDIO SETUP
DIGITAL OUTPUT	PCM
96K LPCM OUT	96k
DYNAMIC RANGE	MAX
SELECT:	SET: ENTER BUTTON
SET DYNAMIC RANGE

ENGLISH

✽To exit the setup mode Press the SETUP button.

27