Denon DVD-A11 manual Color component output connectors PR/CR, PB/CB and Y, Satellite receiver

(2)Connecting to a TV or Monitor Equipped with Color Component Input Connectors

Color component output connectors (PR/CR, PB/CB and Y)

The red (PR/CR), blue (PB/CB) and brightness (Y) signals are output independently, achieving more faithful reproduction of the colors.

•The color component input connectors may be marked differently on some TVs or monitors (PR, PB and Y/R-Y, B-Y and Y/CR, CB and Y, etc.). For details, refer to the TV’s operating instructions.

•Connect in this way if your TV is compatible with Progressive Scan.

DVD-A11

To power outlet

TV

Y PB/CB PR/CR	L	R
COMPONENT VIDEO IN	AUDIO IN

ENGLISH

(3) Connecting to a TV with 21-pin SCART Terminal (For only European model)

•Use the commercially 21-pin SCART cable to connect the TV’s 21-pin SCART terminal to the DVD-A11’s 21- pin SCART terminal (AV1 / AV2).

21-pin SCART terminal

TV

To power outlet

DVD-A11

NOTES:

• Some discs contain copy prohibit signals. If such	• Set the “TV TYPE“ in “VIDEO SETUP“ in
discs are played via a VCR, the copy prohibit	“SETUP“ to comply with your TV's video format.
system may cause disturbance in the picture.	When the TV is PAL formated, set to PAL. (See
	page 18.)

NOTES:

•Use the three commercially available video cords to connect the DVD-A11’s color component output connectors to the TV or monitor.

•Set the “TV TYPE“ in “VIDEO SETUP“ in “SETUP“ to comply with your TV's video format. When the TV is PAL formated, set to PAL. (See page 18.)

•Set the “VIDEO OUT” in “VIDEO SETUP” in “SETUP” to comply with Progressive TV.

•To use with 2-channel audio output, set “2 CHANNEL” in “AUDIO CHANNEL” in “AUDIO SETUP” in “SETUP” at the initial settings. (See page 19.)

•Set the “TV ASPECT” in “VIDEO SETUP” in “SETUP” to comply with your TV’s aspect. (See page 18.)

CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COMPATIBLE WITH THIS PRODUCT AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE. IN CASE OF 525 PROGRESSIVE SCAN PICTURE PROBLEMS, IT IS RECOMMENDED THAT THE USER SWITCH THE CONNECTION TO THE “STANDARD DEFINITION” OUTPUT.

•To improve picture quality, you can change the video signal output from the AV1 terminal from “Video“ to either “S-Video“ or “RGB“ to suit the type of television you are using (See page 18).

•You can also connect other equipment to AV2.

		Satellite receiver
This unit	Video cassette recorder	or decoder

AV1	AV1	VCR
SCART terminal
of TV set
AV2	AV2

NOTES:

•Set the DVD-A11 to the standby mode to output video or audio signals of another device connected to the DVD-A11’s 21-pin SCART terminal.

(If the power is on, the DVD-A11’s video and audio signals are output. If the power is off, the signals of the other device will not be output.)

•To use the 21-pin SCART terminal, set “AUDIO CHANNEL” under “AUDIO SETUP” at “SETUP” to “2 CHANNEL”.

7