DirecTV GCEB0A, GAEB0A manual Installation

3. Press SELECT again to test the first selection on the pop-up menu.

SYSTEM TEST					Wed, Jun 13			10:15 PM
Install
Signal		System Tests
VCR	Begin Test				Xponder Test
Prefs
		Xponder Test
Test		Satellite 101 (A)
New Card					.6(B)
					0.75
Upgrade					(C)
SYSTEM TEST					Wed, Jun 13				10:16 PM
Features
Install
Watch TV
Signal			System Tests
Main Menu
VCR	Begin Test				Xponder Test
Prefs
Test
New Card		Satellite 101 (A) Signal Strength
Upgrade	1–8	95	95	95	94	95	95	94	93
Features	9–16	94	94	93	94	94	92	94	94
Watch TV
	17–24	93	95	93	93	93	92	93	93
Main Menu
	25–32	94	94	95	95	93	94	94	92

Your results will differ slightly from those shown, depending on your geographic location and specific installation. However, if your results are very different from these examples (i.e, rows of zeros or single-digit numbers):

•Highlight the Install tab on the INSTALLATION menu. Verify your settings.

INSTALLATION		Wed, Feb 13		12:16PM
Install
Signal	Dish Pointing	Alignment Mode
VCR
	Dish Type	ZIP Code
Prefs
Test	Autoconfig	Lat/Longitude
New Card
Upgrade	Dish Type:	ZIP Code :
Features	Oval Dish 2	Latitude	:
	Networks:
Watch TV		Longitude :
	0, 3
Main Menu	Switch Type:	Elevation :
	Simple	Azimuth	:
	LNB: Unstacked	Tilt	:

Installation pane

•Re-enter your ZIP code if necessary to verify you have used the correct antenna pointing parameters for your location.

•Check your cable connections.

•Ensure the DIRECTV® Receiver is connected to a modular telephone jack.

Once you have successfully obtained a signal and your test results resemble those shown in the figures, call DIRECTV (or your subscription service provider) to activate service if you have not done so already.

6 Getting Started