Installing remote control To install or replace the remote control batteries:
batteries | 1. | Locate the battery compartment on the back of the remote control. |
| ||
| 2. | Remove the battery compartment cover. |
| 3. | Insert two “AAA” size batteries as shown, observing the correct polarity. |
| 4. | Replace the battery compartment cover. |
Installing batteries in the remote control
Programming the remote control
TV MUTE
Code scanning
You can operate your TV, VCR, and Audio/Video receiver using your
1.Aim your remote control at the component you want to use.
2.Hold down the desired device button (TV, for example).
3.Press the MUTE button for one second.
4.Release both buttons together.
5.The device button (in this example, the TV button) glows and remains lit. If the button does not light, repeat the previous steps.
6.Use one of the two programming methods described above.
To use this method:
1. Repeatedly tap the top part of the CHANNEL (CH) button.
P CH A G E
2.Continue to step through the codes until the component turns off, indicating you have found the correct component code. If you accidentally pass a code that responds or realize you may not have been aiming the remote control at the component, tap the lower part of the CHANNEL (CH) button to step backward through the codes.
3.Press the remote control POWER button to verify the proper code by turning the device on and off.
4.Press the device button (in this example, TV) again to lock in the code.