DirecTV HIRD-B1 manual Federal Comunications Commission FCC Regulatory Information

Page 5

FEDERAL COMUNICATIONS COMMISSION (FCC)

REGULATORY INFORMATION

Federal Communications Commission (FCC)—The system complies with both Part 15 and Part 68 of the FCC rules.

Part 15 compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by removing and applying power to the equipment, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

The user may find the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify and Resolve Radio and TV Interference Problems.” This booklet is available from the U.S. Government Printing Office, Washington, DC.

To meet FCC requirements, only peripherals (computer input/output devices, terminals, printers, etc.) certified to comply with the Class B limits may be attached to this device. Operation with non-certified peripherals is likely to result in interference to radio and TV reception.

To meet FCC requirements, shielded cables are required to connect the device to a personal computer, peripheral, or other Class B certified device.

Part 68 compliance

1.The FCC has established Part 68 of the FCC Rules, which permit this device to be directly connected to the telephone network. Standardized jacks are used for these connections. This equipment should not be used on coin lines or party lines.

2.If this device is malfunctioning, it may also be causing harm to the telephone network; this device should be disconnected until the source of the problem can be determined and until repair has been made. If this is

not done, the telephone company may temporarily disconnect service.

3.The telephone company may make changes in its technical operations and procedures; if such changes affect the compatibility or use of this device, the telephone company is required to give adequate notice of the changes. You will be advised of your right to file a complaint with the FCC.

4.If the telephone company requests information on what equipment is connected to their lines, inform them of:

the telephone number this unit is connected to.

the ringer equivalence number (REN). The number can be found on a label located on the bottom of the equipment.

the Universal Service Order Code (USOC) jack required. This equipment requires a USOC RJ11 jack.

the FCC registration number. The number can be found on a label located on the bottom of this equipment.

Image 5
Contents Model HIRD-B1 Directv or 1-800-204-USSB Important Safety Instructions Service Federal Comunications Commission FCC Regulatory Information Page Table of Contents Programming Your Remote Control How Does All This Work? HUGHES-BRAND Directv SystemWhat You Should Do First Digital Satellite Receiver Directv System ComponentsSatellite Antenna HUGHES-BRAND Directv System Movies Remote ControlChoosing the Best Connections Setting UP Your Directv SystemHook Up the Audio/Video Signals Hook Up the Audio/S-video SignalsSetting UP Your Directv System Hook Up the RF SignalsFinishing Up Installing Batteries in Your Remote ControlNow You Can Turn It On Basic Navigation Front Panel vs. Remote Control KeysControlling the Digital Satellite Receiver Page Installing and Pointing Your 4 Satellite Dish Choosing the Antenna Installation Site Determine Where to Point Your Satellite DishInstallation screen Alignment Result Pop-up PanelInstalling and Pointing Your Satellite Dish Page Selecting a Mounting Option Installation Procedure Installing the Antenna onto a Wooden SurfaceInstalling and Pointing Your Satellite Dish Installing the Antenna onto a Brick Surface Installing the Antenna onto a Cinder Block Surface Toggler installation steps Installing the Antenna onto a Metal Pole Assembling the HANT-3S Antenna Attaching the Antenna Assembly to the Mast or PoleAttaching the Reflector onto the LNB Support Arm Grounding the Base Plate Grounding the Metal Pole MountInstalling and Routing the LNB Coaxial Cable Attaching the LNB to the LNB Support Arm Connecting the Coaxial Cable to the LNBPositioning the Satellite Dish Connecting the Satellite DishRouting the LNB Cable to the Satellite Receiver Pointing the Dish Using the Box Method Page Ussb Authorizing Your ServicePage Channel Banner Watching Satellite ProgrammingBasic Channel Changing OneLine Guide Information BannerLogoBelt TurboTuneData Alternate ServicesAlt. Audio Page Choosing the Guide Style ON-SCREEN GuidesUsing PreSelect to Schedule Programs for Viewing General On-Screen Guide FeaturesProgram Guide SM. Cell Program Guide LG. Cell Logo Guide Title GuideTheme Filters Filtering the GuidesGuide Times Channel ListClass Filters Information ScreenDone ViewCancel Purchase Cancel PreSelectPreSelect To View Buy $Show Times Menu Overview Your RECEIVER’S Menu SystemPlaces to go from the Main Menu Main MenuThings to do on the Main Menu Setup MenuPlaces to go from the Setup Menu Current settings overview Things to do on the Setup MenuScheduler Things to do on the Scheduler screenPurchases Check MailThings to do on the Check Mail screen MessageThings to do on the Purchases screen New CardPlaces to go from the Purchases screen Lock/Unlock Locking ProcedureUnlocking Procedure Things to do on the Preferences screen PreferencesPlaces to go from the Preferences screen Things to do on the Advanced Preferences screen Advanced PreferencesLimits Factory DefaultsData Port Phone PrefixThings to do on the Limits screen Channel ListsMax Rating Max SpendingThings to do on the Channel Lists screen Places to go from the Channel Lists screenThings to do on the Turbotune Setup screen InstallationPlaces to go from the Installation screen Things to do on the Installation screenThings to do on the System Test screen System TestPosition Receiver TestCode Scan Programming the Remote ControlProgramming Your Remote 8 Control Brand Televisions Code EntryAUX Controlling Other Components Using the AUX Button Using the Remote ControlAssigning a Device to a Different Device Key Page Limited Warranty Revision a