EchoStar 44 manual

Page 7

The switch is UL approved to take the place of a ground block.

You can have up to 200 feet of cable between a DISH Pro LNBF and a satellite receiver with the DISH Pro Plus 44 Switch connected at any point along the 200 feet of cable. The cable must be rated for 950 to 2150 MHz. Some cable is labeled “Swept tested to 2150 MHz.” If you are unsure whether your cable is rated to 2150 MHz, check the container it came in or talk to your retailer.

Note: The DISH Pro Plus 44 switch can be installed inside or outside your home or building.

Note: Mount the switch so that the dish connections are horizontal (as shown in Figure 1), and put drip loops in all coaxial cables. This helps prevent water from dripping into switch connections.

8

Image 7
Contents Dish Pro Plus 44 Multi-Dish Switch Installation Guide Important Safety Instructions Coaxial Cable Contents Introduction FeaturesMounting and Connecting the Switch Installation InstructionsPage Mounting the Switch To Switch Input Connect the cables from the receiver’s back panel Point Dish Screen Run Check SwitchDish Pro Plus Installation Summary Non-DISH Pro Installation Summary Satellite reception verified Adding More Switches Dish Pro Plus 44 Connections Wiring DiagramsAdditional Dish Pro Plus 44 Switches Limited Warranty Page Advance Exchange Program Post Receipt Exchange Program Accessory WarrantyReview this Guide If You Need HelpUL Information FCC Rules