EchoStar 44 manual To Switch Input

Page 9

Note: Receiver models 1000, 2000, 3000, 4000, 5000, JVC D-VHS, 7100, and 7200 cannot receive satellite signals connected to the TO DISH PORT f. Therefore, connect LNBFs for the three satellite locations you want these models to receive on TO DISH Ports c through e. It is recommended that FSS LNBFs be connected to PORT f since the receivers listed in this note cannot receive signals from FSS satellites anyway.

3.Connect a cable between TO POWER INSERTER 1 connection on the switch and the power inserter marked

TO SWITCH INPUT 1.

Do not install any devices between the power inserter and the switch. The power from the inserter may damage the device.

The power inserter must be installed in the cable connected to the switch’s TO POWER INSERTER 1 or the switch will not work.

The power inserter is for indoor use only.

10

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Dish Pro Plus 44 Multi-Dish Switch Installation Guide Important Safety Instructions Coaxial Cable Contents Introduction FeaturesMounting and Connecting the Switch Installation InstructionsPage Mounting the Switch To Switch Input Connect the cables from the receiver’s back panel Point Dish Screen Run Check SwitchDish Pro Plus Installation Summary Non-DISH Pro Installation Summary Satellite reception verified Adding More Switches Dish Pro Plus 44 Connections Wiring DiagramsAdditional Dish Pro Plus 44 Switches Limited Warranty Page Advance Exchange Program Post Receipt Exchange Program Accessory WarrantyReview this Guide If You Need HelpUL Information FCC Rules
Top Page Image Contents