Kathrein UFS 790sw, UFS 790si manual First Installation Single-cable system general

FIRST INSTALLATION: Single-cable system (general)

Use the  buttons here to select “One Cable” as “LNB control”. Press the  button to move to the next menu item:

The various options for a single-cable system with Kathrein

components are

summarised at the end of this manual in the “Technical Appendix” section under “Examples of Single-Cable Systems”.

Dependingonthesystemtowhich they are connected, a maximum of four or eight receivers may be connected to a single-cable system (a twin receiver counts as two receivers)

Satellite selection

Press the  button. The following display appears:

If the receiver is connected to an UAS 481 single-cable LNB, it is imperative the two frequencies

(low band/high band) are set to 10200 MHz here.

You can make the settings using either the number pad or the

 buttons.

Use the  buttons here to select the satellites you want to receive with your system. Press the

!(green) button to open the next menu:

Note:	You can only receive the signals from two satellites in your single-cable system if
	a EXU 908 single cable matrix is used. In this case, repeat the “Satellite selection”
	process for the “Position B” line.

16