Kathrein UFS 710sw, UFS 710si manual Edit Channel List, Lock Channels, Rename Favorites List

EDIT CHANNEL LIST

LOCK CHANNELS

Use the  buttons to select the channel to be locked from the Favorites List you have selected. Press the  button to call up the edit menu and use the  buttons to select the “Lock” function.

Confirm the command by pressing the  button. You are now prompted to enter the PIN code (factory default setting: 0000).

The channel you previously selected is now shown with a padlock to its right. In future this channel can be viewed only by inputting the four-digit PIN code.

The channel is also locked on all other channel lists. You need not additionally access the other channel lists to lock the channel.

This function can be restored again using the edit menu (select: “Remove lock”).

RENAME FAVORITES LIST

Use the  buttons to select the Favorites List to be renamed. Press the  button to call up the edit menu and use the  buttons to select the “Rename Favorites List” function. Confirm the

command by pressing the  button. A keypad will now be displayed with which you can enter the desired name alphanumerically using the numeric pad on the remote control. See also the section “Operating instructions”, “Alphanumeric input”.

START BLOCKSELECTION (HIGHLIGHTING SEVERAL CHANNELS)

Use the  buttons to select the channel as the start point from which you want to select further channels. You can only select channels that are listed in succession in your selected Favorites List.

Press the  button to call up the edit menu and use the  buttons to select the “Start Blockselection”

function. Use the  buttons to select the desired channels, starting from the previously selected channel and working upwards or downwards. The selected channels will be highlighted in yellow and marked with a tick at the left side.

When you have highlighted the channels that you wish to select, press the  button to call up the edit

menu once again and use the  buttons to select the desired function (“Remove from Favorites List” or “Remove lock”).

The selected function can now be used in the same way as described for the respective items in this section for a single channel.

57