If the light on your Sky remote control blinks three times, your Sky digibox has checked all the possible settings for the code you used. Check that you have the correct 4 digit code and start again at Step 1.
7. Turn your TV back on again and then press tv guide.
If you see the TV Guide screen, the remote control setup process is complete.
If you do not see the TV Guide screen, you must now complete the following steps.
8.Press tv on your Sky remote control.
9.Hold down select and the green key at the same time for about two seconds, until the red light on the Sky remote control blinks twice.
10.Key in the number of the TV channel that you use for watching satellite TV.
11.Press select on your Sky remote control. The red light blinks twice. The remote control setup process is complete.
If after doing this, you still have problems, call your broadcaster’s helpdesk. For your broadcaster’s helpdesk number, select the Telephone Numbers option from the Services screen.
EXTRA INFORMATION
41