Lennox Hearth H1454, H6977 Wire Shield, Bottom Side View Cables Upper Side View

Step 9. Locate the fireplace control board (Kit Number H1094) and remove it, including the plastic holders (Refer to Figure 1 ).

Step 10. Disconnect the IR cables (ribbon type cables). Refer to Figure 2.

Step 11. Locate the wire harness behind the right hand side frame.

Step 12. Some early units may have a metal wire shield (Figure 3 ). Slide the shield upwards to align the slots to the screws and remove.

Wire Shield

Figure 3

Step 13. Pull the wire harness completely outside the cavity and remove the flexible wire conduit to expose the wires completely (some early units may have binding tape). If provided, save the flexible conduit to re-use.

Step 14. Leave the A/V cables in place. These cables are not being replaced with the Remote Control Kit. Refer to Figures 4 and 5.

Bottom Side View

Figure 4

A/V Cables

Upper Side View

Figure 5

2

NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.