Step 7: While listening to the meter, apply gentle pressure to the top of the dish to move the dish – first slightly downward, then upward to see if you can increase the signal strength further. Carefully adjust the elevation until you’ve maximized the signal. Tighten the Elevation Adjustment Bolts.
Step 8: Repeat Steps
Step 9: The dish should now be peaked to its maximum. Remove the Satellite Finder and plug the LNB directly into the receiver. Confirm the signal strength by checking the
Yoursystem is now inef tunedand ready foractivation.
10. Groundinghet Coaxial Cable
The Shaw Direct dish kit includes the following items to ground the outdoor coaxial cable
•Coax cable connector Grounding Block
•Grounding Wire
•Grounding Clamp
Outdoor coaxial cable that may be subject to static discharge or contact with electrical wiring, must be grounded through a grounding block located as close as possible to the cable entry point.
•Run the Grounding Wire for the coaxial cable from the Grounding Block connector to a cold water pipe nearest the cable entry point.
•Wrap copper grounding strap around cold water pipe. Tighten strap using bolt and secure the ground wire under the binding post nut as illustrated below
IMPORTANT : For more information on grounding refer to the receiver’s User Guide included with your Shaw Direct system.
Fig. Q
Ground block (shown with 2 coax cable feeds And ground wire secured to binding post,)
10