Shaw M1055FR manual Programming a Learned Key

Programming a Learned Key

NOTE: If more than 15 seconds pass between key presses, the remote exits programming.

1.Press SETUP until the last-selected device key

blinks twice, then 9 7 5.

NOTE: If the LED displays one long flash instead, either your batteries are low, or the Atlas Shaw DVR/PVR 5-Device Universal Remote Control has a memory fault. In either case, the remote will not learn a new key. See “Additional Infor- mation” on page 23.

2.Press a device key once (i.e., AUX, DVD, AUD, TV, or CBL) to assign a mode for learning, then

the key that will learn the new code.

3.Place the Atlas Shaw DVR/PVR 5-Device Universal Remote Control head-to-head (about 2" apart) from your original remote control. Also locate the key (on your original remote control) that you want the Atlas Shaw DVR/PVR 5-Device Universal Remote Control to learn.

2"

4.On the original remote, press and hold the key to be learned. The Atlas Shaw DVR/PVR 5- Device Universal Remote Control’s LED will blink rapidly, then turn off. Continue holding the key on the original remote until the Atlas Shaw DVR/PVR 5-Device Universal Remote Control’s LED blinks twice.

NOTE: If the LED displays one long blink, a learning error has occurred. Try repeating this step again until a successful capture occurs. If the function is still not captured, press and hold SETUP to exit programming and review the “Learning Precautions” on the previous page. If needed, also see “Troubleshooting” on page 21. After review, start programming again at step 1.

36