NOTES: For TV/VCR Combo control, skip this section and perform the instructions on “Program- ming TV/VCR Combo Control” on page 10. Also refer to “Device Table” on page 7 to find out which devices can be programmed onto each device key.
If you have another brand of cable converter or a satellite receiver you would like to control, you’ll need to unlock the cable ID Lock before changing the converter code (see “Program- ming ID Lock” on page 18).
1.Turn on a device and, if applicable, insert video media, (e.g., cassette or disc).
NOTE: Please read steps 2 through 4 completely before proceeding. Highlight or write down the codes and device you wish to program before moving on to step 2.
2.On the remote control, press a device key once
(i.e., AUX, DVD, AUD, TV, or CBL); it will blink once. Then press and hold SETUP until the selected mode key blinks twice.
3.Use the “Manufacturer’s Codes (Codes Des Fabricants)” starting on page 49) to locate the type of device and brand name and then enter the first
NOTE: If the selected mode key emits a long blink, the entry is invalid. Repeat steps 2 through 3 and try entering the same code again.
4.Aim the remote control at the device and
press PWR once. The device should turn off. If it does not, repeat steps 2 through 3, trying each code for your brand until you find one that works. If it still does not respond, try searching for the code (see “Searching for Your Code” on page 11).
NOTE: If the device does not have a PWR key, press the (Play) key.
5.Repeat steps 1 through 4 for each device you want the remote control to operate. For future reference, write down each working device code in the boxes on the following page.
AUX Code
Device Type:___________________
9