
PROGRAMMING ID LOCK
TheAtlas PVR Universal Remote Control is locked at the factory to operate a Motorola Digital Cable Terminal (DCT). However, if you have another brand or model of cable converter or satellite service that you would like to control, then you’ll need to perform the following steps to unlock the ID Lock, enter a new manufacturer’s code, and lock the ID Lock again.
1.Turn on the cable converter.
2.On the remote control, press CBL once; it will blink once. Then press and hold SETUP until
the CBL key blinks twice.
3.Enter 9 8 2. The CBL key will blink four
times, indicating ID Lock is unlocked.
4.Perform the instructions under “Programming Device Control” on page 8 to program device control for the desired cable converter or satellite receiver.
When you are done, perform steps 5 and 6 on this page to again lock the ID Lock.
5.On the remote control, press CBL once; it will
blink once. Then press and hold SETUP until the CBL key blinks twice.
6.Enter 9 8 2. The CBL key will blink twice,
indicating ID Lock is again locked.
USING THE MASTER POWER KEY
The Atlas PVR Universal Remote Control has a unique feature that allows you to sequentially turn up to five of your home entertainment devices on or off with a single key press.
NOTE: | MASTER POWER (PWR) only works in the CBL |
| mode. If it is not programmed, only the cable |
| converter will turn on or off. In any other |
| mode, pressing MASTER POWER (PWR) once |
| will turn the selected device on or off. |
18