Shaw ATLAS PVR Universal Remote Control manual RE-ASSIGNING Device Keys

4.Press and hold SETUP until the CBL key blinks twice.

RE-ASSIGNING DEVICE KEYS

The Atlas PVR Universal Remote Control can be set up to control a second device of an already-assigned type. For example, to have the unit control a TV, a Cable Converter, and two DVD players, re-assign the unused AUX key to operate the second DVD Player as follows:

NOTE:	AUX is preset at the factory to control an RCA
	VCR. Performing the steps below will over-
	write those settings.

1.On the remote control, press AUX once; it will blink once. Then press and hold SETUP until the AUX key blinks twice.

2.Enter 9 9 2. The AUX key will blink twice.

3.Press DVD once, then press AUX once. The AUX

key will blink twice.

The AUX key is now ready to be programmed for your second DVD player. See “Programming Device Control” on page 8. To re-assign other device keys, repeat these and substitute the key sequence using the following chart:

NOTE: Only one device can be assigned to an unused device key at a time.

To Re-Assign Perform Key Sequence

AUX as 2nd AUXÆSETUPÆ9Æ9Æ2ÆAUDÆAUX AUD key

AUX as 2nd AUXÆSETUPÆ9Æ9Æ2ÆTVÆAUX TV key

AUX as 2nd AUXÆSETUPÆ9Æ9Æ2ÆCBLÆAUX CBL key

AUX back to AUXÆSETUPÆ9Æ9Æ2ÆAUXÆAUX AUX

To re-assign another unused device key, substitute it for the AUX key above and then perform the sequence. For example, to re-assign an unused AUD key as a second

20