Bell'O 8325, 8315 manual When mounting to a wood stud

Page 12

When mounting to a wood stud

When you have prepared the holes for mounting the Wall Plate (WP), place the plate over the holes and screw in the Lag Bolts (T), as shown in Figure 7. Leave some “wiggle” room so that you can make any fine adjustments, if necessary. After making sure the wall mount is level, tighten all of the lag bolts completely.

Figure 7

Supporting

Stud

WP

Supporting

Stud

Wall

T

Tighten the Lag Bolts (T) so that the Wall Plate (WP) is firmly attached to the wall, but don’t over-tighten! The lag bolts and/or the supporting surface can become damaged, which greatly reduces their holding ability. Final tightening of the bolts should always be done by hand, with a Phillips-head screwdriver or ratchet wrench.

English

Image 12

Contents Page Introduction About This Manual Icons Used in This BookFoolish Assumptions Precautions Parts Included in This Kit WP 8315 or 8325 Wall Plate 8325 Shown, QuantityAB M4 x 10mm Security Screw Tools You Will Need Attaching the Adjustable Arms Getting ready to hang the TVWho is VESA? Choosing which screws to use for your TVSelected Screw Adjustment Lever Attaching the Monitor ArmsSecuring the Wall Plate Finding the wood studs to mount toDetermining the location of the TV Using the Installation Template Installing the Security ScrewWhen mounting to a wood stud When mounting to solid concrete, bricks, or cinder block LevelInstalling the decorative End Covers Don’t forget those wires Mounting the TVUnderstanding the locking mechanism Mounting the TV Locking the arms into place Using the tilting arm feature If you need to remove the TVLimited Lifetime Warranty Bell’O International Corporation