Niles Audio R-6L manual Checking the Codes, Learning Precautions, Programming a Learned KEY

Page 8

CHECKING THE CODES

If you have set up the remote using the procedure in “SEARCHING FOR YOUR CODE”, you may need to find out which five-digit code is operating your equipment. For example, to find out which code is assigned to your TV:

1.Press TV source key once

2.Press and hold SETUP until the red LED blinks twice, then release

3.Enter 9 9 0. The source key LED blinks twice

4.To view the code for the first digit, press 1. Count the source key LED blinks (for example: three blinks = 3), and write down the number.

NOTE: IF A CODE DIGIT IS 0, THE SOURCE KEY LED DOES NOT BLINK

5.Continue through the four remaining digits by pressing the 2 key for the second digit, the 3 key for the third digit, the 4 key for the fourth digit and the 5 key for the fifth digit.

6.To check for other device codes, repeat steps 1—5, substituting the source key for the desired device you would like to check

LEARNING PRECAUTIONS

Your original remote controls must be in working order to learn IR commands properly.

•Learned keys are device-specific, so each key can store a ‘unique function’ for each device

•Do not use the following keys for learning: Source Keys, SETUP

•Learning capacity is approximately 42 to 75 keys, depending on the code being learned

•Certain device functions can not be learned including multi-frequency types, some high frequency codes, and other unusual formats

•For optimum learning, avoid high levels of ambient light such as natural sunlight or energy-efficient fluorescent lights

NOTE: PLEASE HAVE YOUR ORIGINAL REMOTE CONTROLS HANDY BEFORE PROGRAMMING LEARNING

PROGRAMMING A LEARNED KEY

NOTE: IF MORE THAN 10 SECONDS PASS BETWEEN KEY PRESSES, THE REMOTE EXITS PROGRAMMING MODE

1.Place the Niles R-6L or R-8L Hand-Held Learning Remote Control head-to-head (about 2” apart) from your original remote control. Also locate the key (on your original

6

Page 7 Page 9
Image 8
Page 7 Page 9
Contents 6L R-8L Table of Contents CongratulationsNiles R-8L Hand-Held Learning Remote Control IntroductionSetup KEY Volume KeysSource Select Keys On and OFF KeysDirect Access Keys Exit KEYExtended Function Keys DVR Special Function KeysBattery USE and Safety To Install BatteriesConfigure a Source Battery InformationSearching for Your Code Programming a Learned KEY Learning PrecautionsChecking the Codes Deleting a Single Learned KEY Restoring KEY Functions to Factory Settings Deleting ALL Learned Keys of a Specific DeviceProgramming Sequences Programming a Device Independent SequenceTroubleshooting Programming a Device Dependent SequenceSpecifications Limited WarrantyNiles Audio Corporation 1-800-BUY-HIFI
Top Page Image Contents