remote control) that you want the
2.Press and hold SETUP until the source key LED blinks twice, then release.
3.Enter 9 7 5. The source key LED blinks twice.
NOTE: IF THE SOURCE KEY LED DISPLAYS ONE LONG FLASH INSTEAD, YOUR BATTERIES ARE LOW, OR THE
4.Press the key on the Niles
5.On the original remote, press and hold the key to be learned. Continue holding the key on the original remote until the
NOTE: IF THE SOURCE KEY LED DISPLAYS ONE LONG BLINK, A LEARNING ERROR HAS OCCURRED. TRY REPEATING THIS STEP AGAIN UNTIL A SUCCESSFUL CAPTURE IS OBTAINED. IF THE FUNCTION IS STILL NOT CAPTURED, PRESS AND HOLD SETUP TO EXIT PROGRAMMING AND REVIEW THE “LEARNING PRECAUTIONS” ABOVE. IF NEEDED, ALSO SEE “TROUBLESHOOTING”. AFTER REVIEW, START PROGRAMMING AGAIN AT STEP 1.
6.Repeat steps 4 through 5 for another key you would like to learn. Once you have completed learning all keys, press and hold SETUP until the source key LED blinks twice to save all data learned.
DELETING A SINGLE LEARNED KEY
This process returns the key to its original programming for the device you select. You can also delete learned programming by teaching a different function to the key (see “Programming a Learned Key”).
NOTE: IF MORE THAN 10 SECONDS PASS BETWEEN KEY PRESSES, THE REMOTE EXITS PROGRAMMING MODE.
1.Press the source key from which you wish to remove the learned key
2.Press and hold SETUP until the source key LED blinks twice, then release
3.Enter 9 7 6. The source key LED blinks twice
4.Press the key containing the learned function to be deleted twice. The source key LED blinks twice and the remote exits from programming mode
NILES AUDIO CORPORATION – |
| 7 |
|