Battery USE and Safety, To Install Batteries

BATTERY INFORMATION

Your Niles R-6L or R-8L Hand-Held Learning Remote Control requires 2 Alkaline “AA” batteries (included).

BATTERY USE AND SAFETY

•Use only fresh batteries of the required size and recommended type

•Do not mix old and new batteries, different types of batteries (standard, alkaline, or rechargeable), or rechargeable batteries of different capacities

•If you do not plan to use the remote for an extended period, remove the batteries. They can leak chemicals that can destroy electronic parts

WARNING: DISPOSE OF OLD BATTERIES PROMPTLY AND PROPERLY. DO NOT BURN OR BURY THEM.

TO INSTALL BATTERIES

1.Open the battery compartment cover (located on the back of the remote).

2.Place the “AA” batteries in the compartment matching the + and – polarity symbols inside.

3.Replace the cover.

NOTE: WHEN THE BATTERY VOLTAGE IS LOW, A SOURCE KEY LED WILL BLINK 5 TIMES AFTER A KEYPRESS.

CONFIGURATION

CONFIGURE A SOURCE

To conﬁgure the Niles R-6L/R-8L Hand-Held Learning Remote Control to control the connected source devices, follow the steps below. Before proceeding, ﬁnd the codes for the devices you want to conﬁgure in “Manufacturer’s Codes” and write them down or highlight them.

1.Turn on the device (for example: CD player) and, if needed, load media (for example: a CD).

2.Press a Source key (SRC2, SRC3, SRC4, SRC5, SRCL or optionally the TV, Aux) on the R-6L or R-8L that you wish to program.

3.Press and hold SETUP until the source key LED blinks twice, then release.