INSTALLATION
E N G
Warning: To prevent electrical shock, always remove the telephone line cord from the wall jack before removing the cord from the telephone. Never leave the line cord connected to the wall jack if it is not also connected to the telephone.
AC adapter should be unplugged when not in use.
➤Select a Location:
•This unit requires a modular phone jack and a standard 120 volt outlet.
•The unit should be located in an area where it is easy to see the lighted ringer.
•The unit can be used as a desk top phone or a wall mount phone.
➤Connecting Your Walker W-300
The Walker
To install as a Desk Unit:
•Insert AC Adapter into the jack located on the top side of the telephone.
•Locate the hinge slots located on the right and left side of the back of the telephone.
•Turn wall mount bracket so the wide end (end with rubber feet) of the bracket is towards the top.
•Install bracket by inserting the tabs on the bracket into the hinge slots.
•Press down on the top of the bracket to lock into place.
•Plug AC Power Adapter directly into standard 120 volt outlet.
•Plug one end of the telephone line
cord (flat) into the back of the Walker telephone.
•Plug the other end of the telephone line cord into the wall jack.
•Plug one end of the handset cord (coiled) into the bottom of the handset.
•Plug other end of handset cord into the jack located on the lower left side of the telephone and hang up receiver.
•The unit should sit on an angle when used as a desk phone.
L
I
S
H
7
