PROGRAMMING A DEVICE DEPENDENT SEQUENCE
1.Press a source key.
2.Press and hold SETUP until the source key LED blinks twice, then release.
3.Press 9 7 8. The source key LED blinks twice.
4.Press the key to which you wish to assign a sequence.
5.Enter the series of commands (key presses) you want the sequence to execute (up to 15 commands).
6.Press and hold SETUP until the source key LED blinks twice, then release.
Now, when you press the sequence key , the remote sends the series of commands you have entered, but only if the device selected in step 1 Is active. For example, you could program the sequence key to turn on both your TV and cable box and select a particular channel, but only if the TV is selected. If the DVD is selected, this key does not execute the sequence you set up for the TV. To clear the sequence, repeat steps
TROUBLESHOOTING
PROBLEM:
1. LED does not blink when you press a key.
SOLUTION:
• Try pressing different keys. Replace the batteries with 2 new AA batteries
PROBLEM:
2. LED blinks when you press a key, but device does not respond.
SOLUTION:
• Make sure the remote is aimed at your device and is not more than 40 feet away
PROBLEM:
3. Source key LED blinks one long blink while in SETUP mode.
SOLUTION:
• An entry error has occurred (for example, wrong key). Try entering the sequence again
PROBLEM:
4. Remote does not control devices or commands are not working properly.
SOLUTION:
•Try all listed codes for the device. Make sure the device operates with an infrared remote control
| (CONTINUED ON NEXT PAGE) | |
NILES AUDIO CORPORATION – |
| 9 |
| ||