| MCC Card |
3.5ACS-MCC Card Error Messages
Refer to Appendix B in the System Reference Guide for further information on Error Messages regarding this card.
3.6ACS-MCC Card Troubleshooting
MCC card problems could indicate a number of possible causes, including:
•Misconfigured IP parameter at the far end
•Faulty cabling between the MCC LAN port and the LAN
•T1 or E1 network failure
•Improper network configuration
•Improper MCC card configuration
Typically, a problem is indicated by the inability to route IP traffic to/from or through the MCC card. You can perform numerous tasks to isolate the trouble and clear it. When troubleshooting problems on IP communications through an MCC card, follow this general sequence:
1.If all IP traffic is affected, verify that the US/EUR jumper is correctly placed to match the US/EUR jumper on the chassis. The MCC card performs a
2.Verify that the Ethernet Port (E) is actv and that the correct IP address (IPADDR) and NETMASK have been entered. At this point, attempt to “ping” (from the CPU card TCP/IP screen) the IP address of the MCC Ethernet port from another device on the LAN. Pressing N from this screen will display the Network Statistic registers for the Ethernet port. Analyze the information to determine the cause of the failure. Do not proceed with further steps until this ping is successful.
3.From the CPU Main Menu screen, go to the TCP/IP screen by pressing I. Verify that the options and addresses on the TCP/IP screen are correct. Press “P” (for ping) and enter the IP address of the MCC card Ethernet port.
4.If Step 3 is not successful, verify that the DEFAULT IP PORT is set to serv and that the DEFAULT IP SLOT is set to the chassis slot in which the MCC card resides (P1, P2, or P3). At this point, attempt to ping the card again by pressing P. Do not proceed until this ping is successful.
5.Verify that the T1 or E1 network is working properly by checking for current
Server Cards |
