Zhone Technologies 600, 900, 800 manual ACS-FRS Card Main Screen Actions

FRS Card ACS-FRS Card User Screens and Settings

		Table 2-1. ACS-FRS Card Main Screen Actions
	Action					Function
	Save	Saves changes to settings.
	Undo	Returns all settings to the last saved state.
	Refresh	Redraws the screen.
	< and >	Lets you scroll through the 68 logical ports assignable on each ACS-FRS
		card.
	Endp	Brings up the PVC Endpoints Screen where endpoints for each PVC are
		assigned. See the PVC Endpoints Screen section of this chapter.
	Circ	Brings up the Circuits Screen where alternate endpoints and endpoint
		switching are assigned. See the Circuits section of this chapter.
	Perf	Initiates Port Performance Monitoring of the selected ACS-FRS card port.
		Refer to Port Performance Data section of this chapter.
	Lmi	Brings up the LMI Screen where additional performance statistics are
		stored. See the LMI section of this chapter.
	Glob	Brings up the Global Screen that identifies the ACS-FRS card by IP number
		and netmask. See the Global Setup section of this chapter.
	Main	Returns to the System Main Screen. If changes are made to settings and not
		saved, you will be prompted to save or lose changes.
	Table 2-2. ACS-FRS Card Main Screen Option Settings and Defaults
	Parameter				User Options				Notes	Default
STATE			stdby	actv						stdby
WAN/SRV			none	w1-1 w1-2		w2-1	w2-2	w3-1		none
			w3-2	w4-1 w4-2
TS			n/a	table						n/a
RATE			64k							64
PORT TYPE			none	u-dce	nni	u-dte	frad			none
LOOPBACK			off line local							off
LMI			none	ansi	ccitt	lmi			1	none
DCE PARAM			n/a	enabl					2	n/a
DTE PARAM			n/a	enabl					3	n/a
ASYNC			no	yes						no
CONG THRS			enabl	1%-100%					4	enabl (95%)

Notes:

1.ansi, ccitt, and lmi can only be selected when Port Type is changed to any selection other than none.

2.When Port Type is u-dceor nni, this parameter will let you change the Error Threshold, Poll Verify Timer, and Events Counter settings.

3.When Port Type is u-dteor nni, this parameter will let you change the Error Threshold, Poll Interval Timer, Events Counter, and Full Status Frequency.

4.Press <Enter> to select the desired Congestion Threshold percentages.

5.If connected to a user port, this displays user slot number and port (e.g. U1-2).

Server Cards 2-5